mass of coal fired boiler

Details


  • Production capacity: 7-70 MW
  • Work pressure: 1.0-1.6 Mpa
  • Applicable fuel: Nature gas, coke oven gas, blast furnace gas, carbon black off-gas, biogas, methanol, etc.
  • Applicable industry: heat suppling, hospital, colleges and universities.


Product introduction

  SZS Series Boiler is double drums, longitudinal arranged, "D" type chamber structure. Furnace is on right side and convection tube bundle is on the left. The body is fixed on the basement by middle and both end flexible supports and make the boiler to expand horizontally to sideways. Around furnace is membrane water cooling tube wall. Furnace and tube bundle is totally separated by the membrane water tube cooling wall at the left side of the furnace. The back part of bundle is sparse shift structure, front part is aligned structure. Smoke from furnace outlet enters re-burning chamber, bundle area, and then from left front part enters spiral fin coil economizer and condenser, finally discharged to atmosphere through chimney.





Safety

  Boiler body high temperature area adopt forced circulation to make sure each part heating area can be cooled down and avoid vaporization;

  Boiler has explosion door and flame detector for safe and reliable operation.

  comb plates are used as the sealing between both sides of boiler and tube bundle all use to avoid leakage of condensate and gas which is caused by refractory concrete sealing.

  air tightness test is done before leaving the factory to ensure no leakage of gas.

environmental protection

  Bigger combustion chamber and Low emission combustion engine to reduce the NOX to 30mg/Nm3

  Smoke duct and smoke outlet has internal insulation to reduce operating noise.

  Combustion chamber use full membrane water cooling wall structure, pressurized firing without smoke mixture.

energy conservation

  Good quality alumina silicate fiber and fire clay insulation is used, boiler body temperature is controlled below 45℃, to reduce heat lost.

  Combustion chamber use narrow distance tube membrane water cooling wall which has good air tightness, and reduce heat lost and increase boiler thermal efficiency.

  Inside of Inspection holes use high-alumina refractory and man hole cover sealing devices, it solved the high temperature of this part by using refractory brick

Convenience

  Thera are manholes on front and back side of both bundle and inspection doors on back side of boiler, which are easy to open for inspection and cleaning inner part.

longer lifespan

  Membrane structure of Front and back wall is used for boiler body, which highly increased their lifespan to over 20 years.

  The key part such as material cutting, rolling, drilling are proceeded by advanced CNC machining process to reduce the assemble stress and extend boiler working lifetime.

  flutter prevention fastener is used for high temperature part convection tube, which avoid bundle tube cracking problem.

  Longitudinal and girth joint adopt advanced automatic submerged-arc welding for good welding quality. All longitudinal and girth joint will have 100% radiographic inspection.

 
Items
Model
SZS7-1.0/115/70-Q SZS10.5-1.0/115/70-Q SZS14-1.25/115/70-Q SZS17.5-1.25/115/70-Q SZS21-1.25/130/70-Q SZS29-1.25/130/70-Q SZS46-1.6/130/70-Q SZS58-1.6/130/70-Q SZS70-1.6/130/70-Q SZS116-1.6/130/70-Q
Rated thermal power(MW) 7.0 10.5 14.0 17.5 21.0 29 46 58 70 116
Rated working pressure(MPa) 1.0 1.0 1.25 1.25 1.25 1.25 1.6 1.6 1.6 1.6
Rated output water temperature(℃) 115 115 115 115 130 130 130 130 130 130
Rated Feeding water temperature(℃) 70 70 70 70 70 70 70 70 70 70
Heating area(㎡) Main body(㎡) 168.0 220.0 245.30 284.40 394.75 428.1 1065.9 1225.7 1408.4 6164.8
Condenser (㎡) 164.0 306.0 527.0 645.1 738.3 990.8 985.3 1292.5 1642.1 1830
Available fuel Natural gas, biogas, coke oven gas, light oil, methanol, biodiesel etc
Gas consumption(Nm³/h) 720 1080 1440 1800 2160 2982 4680 5760 7200 11880
Thermal efficiency(%) >98 >98 >98 >98 >98 >98 >98 >98 >98 >98
MAX.transportation weight(t) 42.0 48.0 52.5 57.5 65.0 72.5 散件12.6 散件13.8 散件16 散件20
MAX. transportation dimension LxWxH(m) 7.87x3.40x3.34 8.85x3.85x3.93 8.51x3.85x3.75 9.31x3.77x3.75 10.10x4.13x4.15 10.90x4.13x4.15 11.00xΦ1.45 11.10xΦ1.46 12.00xΦ1.66 12.50xΦ1.66

CONTACT FORM



fabricate and install complete coal fired boiler systems from the fuel storage system thru exhaust gas Coal Fired Boilers Downloads. Biomass Alternative Fuel

Biomass Cofiring in Coal-Fired Boilers

Biomass Cofiring in Coal-Fired Boilers Using this time-tested fuel-switching technique in existing To determine the cofiring rate (percent biomass) on a mass,

Industrial biomass fired wood chips, roasted chaff, lignite, washery rejects, paper sludge, coal as biomass fuel to Rick husk Biomass Fired Boiler

Coal fired boilers, wood boiler,other Bio-mass boilers, Lignite Membership : SubmitSite : Online Calculations : Grate Fired Boiler :

DS1100 Aqua-gem Wood or Coal Fired Boiler. Burns Wood and Coal; Firebox: 16.5 " x 19" Size: 23.5"W x 49.5"H x 28"D; Approx. 27 gal. Standard 6" flue; Weight: 800 lbs.

(USCPC) plants. The primary difference between the three types of pulverized coal boilers are the operating temperatures and pressures.

Products &8211; Keystoker Wood, gas, pallet burning stoves

gives you the highest possible efficiency in a coal stove. Furnace is heated with our Coal Boilers. The Keystoker Hand-fired boiler offers

Fire Tube Boilers both fired and waste heat type (Steam Boiler and Bio-mass/Coal fired Boiler. basic boiler design. There are articles on Boiler

Boiler Drawings Many sample Steam Generators drawings are available at Boiler Drawings section. General Arrangement drawings and Pressure Part assembly

A Coal-Fired Thermoelectric Power Plant, from the USGS Water Science School.

Apr 02, 2013&0183;&32;Heat rate is the single paramter that can tell the health of a power plant similar to the pusle rate of a person tells about ones health.

Conventional coal-fired power plant &8211; encyclopedia

The steam generator. A conventional coal-fired steam generator is a rectangular furnace about 15 metres on a side and 40 metres tall. Its walls are made of insulated

Exergy Analysis and Efficiency Improvement of a Coal Fired Thermal Power Plant in Queensland. By R. Mahamud, M.M.K. Khan, M.G. Rasul and M.G. Leinster

We bring forth an impregnable range of Direct Fired Hot Air generator. These sets are available in different shapes and sizes. Being very easy to operate, these are

Do you have the install information That would describe the type of &8216;fireplace&8217; and chimney you have Then ask the Mfg. if you can install a coal insert in it

Balkrishna Boilers Private Limited is incepted in the year 1982. We are affianced in manufacturing and wholesaling Process Heating Equipment to our clients.

Estimates of Emissions from Coal Fired Thermal

1 Estimates of Emissions from Coal Fired Thermal Power Plants in India Moti L. Mittal. Department of Environmental and Occupational Health, University of South

November 19, 2011 Air Pollution Under legal pressure, Wisconsin coal-fired power plants curb emissions But health concerns remain as state, federal regulators take

1. Introduction. Recent years saw rapid industry development and boosted energy demands in developing countries . However, this trend leads to serious problems such

The direct cost of electric energy produced by a thermal power station is the result of cost of fuel, capital cost for the plant, operator labour, maintenance, and

Jun 18, 2013&0183;&32;SPRINGFIELD Eastman Chemical Co. announced Tuesday that it will convert a coal-fired boiler at the former Solutia plant in Indian Orchard to natural

Fly ash &8211; Wikipedia, the free encyclopedia

Fly ash, also known as "pulverised fuel ash" in the United Kingdom, is one of the residues generated by coal combustion, and is composed of the fine particles that